LevelOne WBR-1100TX, WBR-1400TX manual Connect WAN Cable

Installation

4. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the LevelOne Wireless Broadband Router. Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.

5. Connect Printer Cable

Use a standard parallel printer cable to connect your printer to the Printer port on the Leve- lOne Wireless Broadband Router.

6. Power Up

•Power on the Cable or DSL modem.

•Connect the supplied power adapter to the LevelOne Wireless Broadband Router and power up.

Use only the power adapter provided. Using a different one may cause hardware damage

7. Check the LEDs

•The Power LED should be ON.

•The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

•For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is also ON.)

•The WAN LED should be ON.

•The Wireless LED should be ON.

•If the printer is On and On-line, the Print Act LED should be ON.

For more information about the LEDs, refer to LEDs - WBR-1400TX in Chapter 1.

13