Lexmark 90T7110 manual Tips for scanning, Scanning to a local computer, Scanner glass

Scanning 27

Scanning

ADF Scanner glass

Use the scanner glass for single pages, small items (such as postcards or photos), transparencies, photo paper, or thin media (such as magazine clippings).

Use the ADF for multiple‑page documents.

Note: The ADF is available only on select models. If you purchased a printer without an ADF, then load original documents or photos on the scanner glass.

Tips for scanning

•Use the scanner glass when scanning two‑sided pages if your printer does not support duplex scanning or the ADF does not support the original document size.

•When using the ADF, adjust the paper guide on the ADF to the width of the original document.

•When using the scanner glass, close the scanner cover, if possible, to avoid dark edges on the scanned image.

•Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine clippings) into the ADF. Place these items on the scanner glass.

•When the document to be scanned is in place with the settings you want, pressto start scanning.

Scanning to a local computer

1Load the original document faceup into the ADF or facedown on the scanner glass.

2From the printer control panel, navigate to:

> Scan > > Computer > USB‑Connected Computer >

The USB‑connected computer will receive the scan by default.

Note: Make sure the scan software is installed on the destination computer.

3Press the up or down arrow button to scroll to the scan option you want to set, and then press the left or right arrow button to scroll to the setting you want.

Set the color, quality, original image size, and other scan options. If necessary, press each time you make a selection.

4Press .

Scanning to a flash drive or memory card

Notes:

•Some features are available only in select printer models.

•Make sure your flash drive or memory card is not write‑protected.

1Load the original document faceup into the ADF or facedown on the scanner glass.

2From the printer control panel navigate to: > Scan > > Memory Device

3Insert the flash drive or memory card, and then press .

Note: The printer reads only one memory device at a time.

4Press the up or down arrow button to scroll to the scan option you want to set, and then press the left or right arrow button to scroll to the setting you want.

Set the color, quality, original image size, and other scan options. If necessary, press each time you make a selection.

5Press .

Follow the instructions on the printer display.