48
44

STEP 26:

FIGURE 26
24

STEP 27:

FIGURE 27
• SECURELY assemble the PIVOT ARM (5) to the LEG CURL/EXT FRAME (92) using four previously inserted 3/8 X 76mm BUTTON
HEAD BOLTS (63), four RH WASHERS (67), four 3/8” SAE WASHERS (66), four 3/8” LOW HEIGHT LOCK NUTS (65) and four RH
CAPS (69) as shown in FIGURE 26.
• IMPORTANT! When PIVOT ARM (5) is centered and level in the PILLOW BLOCKS (25), tighten the PILLOW BLOCK set
screws.
25
5
65 6667
69
92
• Insert one 5-1/2” TAPPED PIVOT SHAFT (83) into the PIVOT ARM (5).
• SECURELY assemble the MULTI PRESS ADJUST PLATE (20) to the PIVOT ARM (5) using three RH CAPS (69), three
BLACK RH CAPS (68), one 3/8 X 67mm BOLTS (55), one 3/8 X 73mm BOLT (57), one 3/8 X 90mm BOL T (58), six 3/8” SAE W ASH-
ERS (66), six 3/8” RH WASHERS (67), one 3/8 X 3/4” FLANGE SPACER (48), one 3/8 X 1” FLANGE SP ACER (44), one MULTI
PRESS CABLE (73) and three 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 27. (NOTE: Assemble the MULTI PRESS
CABLE to the second set of holes.)
3/8 X 73mm 57
5
83
65
66
68 BLACK
67
73
20
69
58 3/8 X 90mm
TIGHTEN!
69
68 BLACK
55 3/8 X67mm