29

STEP 32:

FIGURE 32
11
65
26
• Route the MULTI PRESS CABLE (73) through the LAT/LOW BOOM (11) and assemble one 4-1/2” PULLEY (26) to the BOOM
(11) using one BLACK RH CAP (68), one RH CAP (69), one 3/8 X 70mm BOLT (56), two 3/8” SAE WASHERS (66), two 3/8” RH
WASHERS (67), one 2-7/8” X 2-1/4” CABLE CLIP (28), two 3/8 X 1/2” FLANGE SPACERS (46) and one 3/8” LOW HEIGHT LOCK
NUT (65) as shown in FIGURE 32.
• Slide one WEIGHT STACK PIN (38) over the stem on the HEAD PLATE (36) as shown in FIGURE 32.
• Screw the threaded end of the MULTI PRESS CABLE (73) all the way onto the end of the stem on the HEAD PLATE (36) and
tighten jam nut securely. See FIGURE 32.
3/8 X 70mm 56
66
36
38
73
68
BLACK
67
46
28
69
01
1/2 1/2 1/2 1/2 1/2 1/2
23456
10 20 30 40 50 60 70 80 90 100 110 120 130 140 150