Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
|
| TROUBLESHOOTING & REPAIR |
WELD CONTROL OR PERIPHERAL PC BOARD
REMOVAL AND REPLACEMENT
WARNING
Service and repair should be performed by only Lincoln Electric factory trained personnel. Unauthorized repairs performed on this equipment may result in danger to the technician or machine operator and will invalidate your factory warranty. For your safety and to avoid electrical shock, please observe all safety notes and precautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department for electrical trou- bleshooting assistance before you proceed. Call
DESCRIPTION
The following procedure will aid the technician in removing and replacing the Weld Control or Peripheral PC Board on the
MATERIALS NEEDED
3/8" Nut driver, wrench or socket wrench 5/16" Nut driver
Wiring Diagram
This procedure should take approximately 30 minutes to perform.
