Lincoln Electric SVM192-A Auxiliary Power, 120/240 VOLT DUAL VOLTAGE RECEPTACLE, Motor Starting

Return to Section TOC

Return to Master TOC

A-7	INSTALLATION		A-7
AUXILIARY POWER		GND
The EAGLE 10,000 can provide up to 9,000 watts of
120/240 volts AC, single phase 60Hz power for contin-
uous use, and up to 10,000 watts of 120/240 volts AC,
single phase 60Hz power peak use. The front of the
machine includes three receptacles for connecting the
AC power plugs; one 50 amp 120/240 volt NEMA 14-
50R receptacle and two 20 amp 120 volt NEMA 5-20R		120 V
loads up to rated capacity. See	Table I for more infor-
receptacles. Output voltage is	within +/-10% at all	240 V
mation.
		120 V*

CAUTION

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Do not connect any plugs that connect to the power receptacles in parallel.

------------------------------------------------------------------------

Start the engine and set the “IDLER” control switch to the desired operating mode. Set the “CONTROL” to

10.Voltage is now correct at the receptacles for auxil- iary power.

120/240 VOLT DUAL VOLTAGE RECEPTACLE

The 120/240 volt receptacle can supply up to 38 amps of 240 volt power to a two wire circuit, up to 38 amps of 120 volts power from each side of a three wire cir- cuit (up to 76 amps total). Do not connect the 120 volt circuits in parallel. Current sensing for the automatic idle feature is only in one leg of the three wire circuit as shown in the following column.

*Current Sensing for Automatic Idle. (Receptacle viewed from front of Machine)

120 V DUPLEX RECEPTACLES

The 120V auxiliary power receptacles should only be used with three wire grounded type plugs or approved double insulated tools with two wire plugs.

The current rating of any plug used with the system must be at least equal to the current load through the associated receptacle.

MOTOR STARTING

Most 1.5 hp AC single phase motors can be started if there is no load on the motor or other load connected to the machine, since the full load current rating of a

1.5hp motor is approximately 20 amperes (10 amperes for 240 volt motors). The motor may be run at full load when plugged into only one side of the duplex receptacle. Larger motors through 2 hp can be run pro- vided the receptacle rating as previously stated is not exceeded. This may necessitate 240V operation only.

Return to Section TOC

Return to Master TOC

EAGLE 10,000 Extension Cord Length Recommendations

(Use the shortest length extension cord possible sized per the following table.)

Current	Voltage	Load			Maximum Allowable Cord Length in ft. (m) for Conductor Size
(Amps)	Volts	(Watts)	14 AWG		12 AWG		10 AWG		8 AWG		6 AWG		4 AWG
15	120	1800	30	(9)	40	(12)	75	(23)	125	(38)	175	(53)	300	(91)
20	120	2400			30	(9)	50	(15)	88	(27)	138	(42)	225	(69)
15	240	3600	60	(18)	75	(23)	150	(46)	225	(69)	350	(107)	600	(183)
20	240	4800			60	(18)	100	(30)	175	(53)	275	(84)	450	(137)
38	240	9000					50	(15)	90	(27)	150	(46)	225	(69)
				Conductor size is based on maximum 2.0% voltage drop.

EAGLE™ 10,000