Linksys SPA 900 manual IVR Options, IVR Action IVR Menu Choice Parameters

Chapter 2 Getting Started

Using the Interactive Voice Response Interface

Step 1 On a SPA901rt of the Linksys IP phone.

Step 2 Press **** (quickly press the star key four times).

Wait until you hear “Linksys configuration menu.”

Note You cannot access the IVR from a phone that is currently connected to a call.

Step 3 Refer to Table 2-2to identify the option required.

Step 4 Enter the required option followed by the # (pound) key. To enter a period, use the star key (*).

When entering a value, such as an IP address, to exit without entering any changes, press the * (star) key twice within half a second. Otherwise, the * is treated as a decimal point.

After entering a value, such as an IP address, press the # (pound) key to indicate you have finished your selection. To save the new setting, press 1. To review the new setting, press 2. To re-enter the new setting, press 3. To cancel your entry and return to the main menu, press * (star).

For example, to enter the IP address 191.168.1.105 by keypad, press these keys: 191*168*1*105. Press the # (pound) key to indicate that you have finished entering the IP address. Then press 1 to save the IP address or press the * (star) key to cancel your entry and return to the main menu.

If the menu is inactive for more than one minute, the Linksys IP phone times out. You need to re-enter the menu by pressing ****.

Step 5 To exit the menu, hang up the telephone.

The settings you have saved take effect after you hang up the telephone. The Linksys IP phone may reboot at this time.

IVR Options

Table 2-2summarizes the options provided by the IVR.

Table 2-2 IVR Options

IVR Action	IVR Menu Choice	Parameter(s)	Notes
Enter IVR Menu	* * * *	None	Ignore SIT or other tones until you hear,
			“Linksys configuration menu. Enter
			option followed by the pound key or
			hang-up to exit.”
Exit IVR Menu	3948	None
Check DHCP	100	None	IVR announces whether DHCP is enabled
			or disabled.
Enable/Disable DHCP	101	Enter 1 to enable	Requires password
		Enter 0 to disable
Check WAN IP Address	110	None	IVR announces the current IP address of
			the WAN port.
			Linksys IP Phone Administrator Guide
Firmware Version 5.1				2-17