
Chapter 5 | Configuring the Switch |
The following capabilities are supported..
•10half Supports 10 Mbps
•10full Supports 10 Mbps
•100half Supports 100 Mbps
•100full Supports 100 Mbps
•1000half Supports 1000 Mbps
•1000full Supports 1000 Mbps
•Sym (Gigabit only) Check this item to transmit and receive pause frames, or clear it to autonegotiate the sender and receiver for asymmetric pause frames..
Flow Control Allows automatic or manual selection of flow control..
Port Broadcast Control
Status To enable broadcast control on a specified port, mark the Enabled checkbox for that port..
Threshold You can protect your network from broadcast storms by setting a threshold for broadcast traffic for all ports.. Any broadcast packets exceeding the specified threshold will then be dropped..
After you modify the required port settings, click Apply..
Port Management > Link Aggregation
You can create multiple links between devices that work as one virtual, aggregate link (LAG).. An aggregated link offers a dramatic increase in bandwidth for network segments where bottlenecks exist, as well as providing a
Port Management > Link Aggregation
LAG Displays the LAG number..
Description Displays the description assigned to the interface..
Administrative Status Indicates whether the interface is enabled or disabled..
Type Indicates if a LAG has been manually configured (static) or dynamically set through LACP..
Link Status Displays the status of the link.. Speed Displays the port speed..
Duplex Displays the duplex mode.. Flow Control Displays the flow control..
Create To create a new LAG, click the Create button in the Create column, then add members to the LAG by clicking on the Select Member button.. The select member screen for the Link Aggregation opens..
Port Management > Link Aggregation > Select Member
The LAG number is shown in the LAG
Detail To configure the LAG and the LAG broadcast control, click the Detail button.. The Link Aggregation detail screen will be displayed..
Port Management > Link Aggregation > Detail
18 |