Linksys SRW224G4P manual Setup Time, Set Time

Chapter 5 Configuring the Switch

IP Address  Address of the VLAN interface that is allowed management access.. Valid IP addresses consist of four numbers, 0 to 255, separated by periods.. (Default: 192.168.1.254)

Subnet Mask  This mask identifies the host address bits used for routing to specific subnets.. (Default: 255.255.255.0)

Default Gateway  IP address of the gateway router between this device and management stations that exist on other network segments.. (Default: 0.0.0.0)

DNS Server  Enter the IP address of the DNS server into the text field.. A second DNS address can be specified in the additional text field provided..

Click Save Settings to save the changes..

Click Restart DHCP to assign a new IP address using DHCP..

Setup > Time

Simple Network Time Protocol (SNTP) allows the Switch to set its internal clock based on periodic updates from a time server (SNTP or NTP).. Maintaining accurate time on the Switch enables the system log to record meaningful dates and times for event entries.. If the clock is not set, the Switch will only record the time from the factory default set at the last bootup.. When the SNTP client is enabled, the Switch periodically sends a request for a time update to a configured time server.. You can configure up to two time server IP addresses.. The Switch will attempt to poll each server in the sequence..

Setup > Time

Set Time

Set the system time manually  This option allows you to set the time and date manually for the Switch..

Set the system time using Simple Network Time Protocol (SNTP) automatically  Sets the system clock automatically using SNTP..

Manual

Hours  The hour is entered here..

Minutes  The minutes is entered here..

Seconds  The seconds is entered here..

Month  The month is entered here..

Day  The day is entered here..

Year  The year is entered here..

Automatic

Sets the system clock automatically using SNTP..

Time Zone  Set the time zone by selecting it from the drop-down menu..

Daylight Savings  Enable daylight saving time by checking the checkbox.. Then set USA, Europe, or custom daylight saving time by clicking the appropriate option..

Time Set Offset  Custom daylight saving time is set by entering the time difference in minutes into the Time Set Offset field.. Set the date for this offset by entering the day and month (DD/MM) in the From and To fields..

Recurring  To enable a recurring custom daylight savings time, check the Recurring checkbox.. Set the day, week, and month the time difference will be recurring (From and To) by using the drop-down menus.. Set the time (From and To) of the recurrence using the field provided (HH:MM)..

SNTP Servers 

Sets the IP address of up to two SNTP servers.. Server 1  Set the IP address of the SNTP server..

Server 2  Set the IP address of an additional SNTP server..

Polling Internal (16-16384 sec)  The value entered here determines the number of seconds between each time the Switch contacts the SNTP server for an update..

24-Port 10/100 + 4-Port Gigabit Switch with WebView and Power over Ethernet 16