Appendix B: Connecting a PTZ Camera

Appendix B: Connecting a PTZ Camera

You can connect RS-485 PTZ cameras (not included) to the RS485 ports on the rear panel.

To connect a PTZ camera to the system:

1Connect the Transmit+ (TX+) Cable to the + side of the RS485 port on the rear panel.

2Connect the Transmit- (TX-) Cable to the - side of the RS485 port on the rear panel.

3Connect the video cable to a BNC port.

8-channel model shown

TX+

TX-

BNC

Alarm block on 16-channel model

NOTE: Use a flat-head screwdriver to loosen the screws above the RS485 ports, then insert the cables and tighten the screws to secure

Configuring PTZ Settings

Before you can use the PTZ controls, you must enter your camera’s PTZ protocol details into the DVR.

Prerequisite:

•Obtain the PTZ protocol details for your camera. Check your camera’s instruction manual for details.

To enter PTZ camera settings in the DVR:

1Right-click to open the Menu Bar and click the Main Menu button ().

2Click Device and select the PTZ tab.

106