Using the Main Menu

•Sensitivity: Select motion sensitivity. The greater the number, the greater the sensitivity.

•Alarm Out: Select the checkbox to enable the system to trigger a device connected to the alarm block.

•Latch Time: Enter the duration the alarm continues to trigger after the event ends.

•ShowMessage:Selectthecheckboxifyou want the system to display a system message when an alarm triggers.

•Buzzer: Select the duration the system will "beep" when motion is detected. Or select OFF to disable the "beep" during motion events.

•Send Email: Select the checkbox if you want the system to send email notifications if an alarm triggers. Email notifications must be configured.

•Record Channel: Select the channel you wish the DVR to record during motion recording.

•Full Screen: SelecttheFull Screen check boxsothatthesystemgoesintofullscreen mode when motion or an alarm trigger is detected.

•Post Recording: Enter the post recording duration(thetimethesystemcontinuesto record after a motion event occurs).

3Click Apply to save your settings.

Configuring Alarm Settings

The Alarm settings menu allows you to configure how the system behaves when an external alarm device (not included) is triggered.

To configure the Alarm tab:

1From the Alarm menu, click the Alarm tab.

2Configure the following:

•Alarm In: Select the channel you wish to configure.

•Alarm Type: Select the alarm type of the device.ChoosefromN/O(normallyopen), N/C (normally closed).

•Alarm Out: Select the checkbox to enable the system’s alarm block to trigger a connected external alarm.

•Latch Time: Enter the duration the alarm continues to trigger after the event ends.

•ShowMessage:Selectthecheckboxifyou want the system to display a system message when an alarm triggers.

•Buzzer:Selectthecheckboxtoenablethe system to "beep" if an alarm triggers.

•Send Email: Select the checkbox if you want the system to send email notifications if an alarm triggers.

•Post Recording: Select the duration the system continues to record as an event afterthealarmtriggerends.Forexample, if you select 30s (30 seconds), the system continues to record for 30 seconds after the alarm trigger ends.

•Full Screen: Select the Full Screen check boxsothatthesystemgoesintofullscreen mode when motion or an alarm trigger is detected.

3Click Apply to save your settings.

45