1.1.2 Hot Installation Preparation

Refer to your system’s hardware user’s manual for complete instructions regarding hot installation.

1.1.3 Installation

Review your system’s documentation for the complete instructions before performing the following steps to install the LSI7202CP into your system:

Step 1. Identify the slot number where you want to insert the adapter.

Step 2. Refer to the system’s documentation for instructions on how to remove the filler panel.

Step 3. Remove the filler panel from the slot you selected.

Step 4. Push on the red release button and open the LSI7202CP card’s ejection lever before installing the card in the system.

Step 5. Pull back the ejection lever and slide the card into the

CompactPCI slot.

Step 6. Apply even pressure at both corners of the card and push the card until it is firmly seated in the slot.

Step 7. Push the ejection lever over the sprocket toward the card and into the locked position. This locks the card into the slot.

Step 8. Use a Phillips screwdriver to tighten the captive screws inside the card’s ejection lever.

Step 9. Attach the Fibre Channel cable to either Port 0 or Port 1 of the LSI7202CP. This completes the hardware installation.

Important: Check your system’s documentation for any additional actions that may be required to configure the system software for the newly inserted card.

1-2

Installing/Extracting the LSI7202CP Host Adapter

Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.