system assigns. This number helps to identify the bus that is reporting
| the error. |
|
Table 4.1 | Error Messages |
|
|
| |
Error Messages | Explanation | |
|
| |
itmpt<n>: This hardware not | itmpt has been told to control an MPT device that is made by a | |
supported by this driver. | manufacturer other than LSI Logic/IntraServer. This adapter | |
|
| requires a special driver provided by that manufacturer. Please |
|
| contact the manufacturer for assistance. |
|
| |
itmpt<n>: Failed to map device | itmpt was unable to access the hardware registers necessary | |
registers. |
| for operation. The operating system did not properly configure |
|
| the PCI device. Make sure your adapter has LSI Logic Fcode, |
|
| and that the adapter is working correctly at the SUN Open Boot |
|
| PROM (OBP) prompt. |
|
| |
itmpt<n>: Hardware not properly | The system has not properly enabled the configuration | |
enabled by system, cmd=xxxxh. | resources that itmpt needs in order to use this hardware. The | |
|
| cmd=xxxxh value must be reported to LSI Logic technical |
|
| support. |
|
| |
itmpt<n>: Could not allocate | The driver was unable to allocate memory required to process | |
memory to read configuration data. | the configuration data. This means that the configuration was | |
|
| not properly determined. To fix this, you may need to manually |
|
| configure the driver using the itmpt.conf file. |
|
| |
itmpt<n>: Unable to make reset | The itmpt was unable to notify the target device driver of a bus | |
notification callbacks. | reset. The target driver may start to malfunction. | |
|
| |
itmpt<n>: ddi_dma_unbind_handle: | The operating system failed to respond to the named routine in | |
failed |
| a known manner. This is a fatal error that is not recoverable. |
|
| Please report this error to technical support. |
|
| |
itmpt<n>: ddi_dma_numwin() failed. | – | |
|
| |
itmpt<n>: ddi_dma_getwin() failed. | – | |
|
| |
itmpt<n>: ddi_dma_alloc_handle: | – | |
xxh unknown/impossible. |
| |
|
|
|
itmpt<n>: |
| – |
ddi_dma_buf_bind_handle: |
| |
DDI_DMA_INUSE impossible. |
| |
|
|
|
itmpt<n>: |
| – |
ddi_dma_buf_bind_handle: xxh |
| |
unknown/impossible. |
| |
|
| |
itmpt<n>: No KeyROM found. | The adapter is not a valid LSI Logic adapter licensed for use | |
Hardware contains no valid license. | with Solaris systems. | |
|
|
|
Solaris Software Requirements | ||
Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.