2.Does the LED on the adapter indicate LINK? (note that LINK is only valid after the device is probed)

3.Does the LED on the switch or remote enclosure indicate LINK?

4.Does the LINK-SPEED parameter selected by the adapter match that of the bus (1G, 2G, or Auto)?

If you do not see disks, the following additional debug information may help to identify the problem.

3.1.5.3 Verifying Correct Installation

Use this procedure to verify installation of your Fusion-MPT adapter in the system:

Step 1. Power on the system.

Step 2. When the banner displays, press the Stop-Akeys to interrupt the boot process and stop at the ok prompt.

Step 3. Use the show-devscommand to list the system devices. You should see an output similar to the following:

ok show-devs

/SUNW,UltraSPARC-III@0,0 /virtual-memory /memory@m0,0

/aliases

/options

/openprom

/chosen

/packages

/upa@8,480000/SUNW,ffb@0,0

...

/pci@8,700000/IntraServer,fc@2

/pci@8,700000/IntraServer,fc@1,1

/pci@8,700000/IntraServer,fc@1

...

/pci@8,700000/IntraServer,fc@2/disk

/pci@8,700000/IntraServer,fc@2/tape

/pci@8,700000/IntraServer,fc@1,1/disk

/pci@8,700000/IntraServer,fc@1,1/tape

/pci@8,700000/IntraServer,fc@1/disk

/pci@8,700000/IntraServer,fc@1/tape

/pci@8,700000/scsi@6,1/tape

/pci@8,700000/scsi@6,1/disk

3-8

BIOS Features

Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.