ok

•/pci@8,700000/IntraServer,fc@1

identifies thefirst Fibre Channel interface on an LSI Logic LSIFC929- based adapter

•/pci@8,700000/IntraServer,fc@1,1

identifies thesecond Fibre Channel interface on an LSI Logic LSIFC929-based adapter

•An LSI Logic LSIFC909-based adapter shows only one such Fibre Channel device

Note: The above are examples. The output of show-devsmay vary depending on your system and configuration. Use the corresponding entries on your system, not the ones given here.

If these devices are not listed, check that the adapter is correctly installed, and re-seat the adapter if necessary.

3.1.5.4 Adapter-Specific Settings

In certain circumstances, the advanced user may want to change settings for an individual adapter or port, without affecting the other adapters in the system. Specific examples of such settings are Fibre Channel bus speed, host adapter ID (SCSI only: Not Applicable to Fibre Channel), and Interrupt Coalescing.

To select a specific Fusion-MPT adapter as the current adapter, use the select command. Selecting a port or adapter will bring the port online, and will allow you to show or set certain adapter specific parameters.

You should use caution while issuing the following commands, as certain commands could render the bus unusable (such as forcing 1 Gbit/s operation on a 2 Gbit/s Fibre Channel loop).

select – Use the select openboot command to select the adapter entry. This will open the port to bring the port online.

ok select /pci@8,700000/IntraServer,fc@1

.properties – Use .properties to show the adapter properties.

ok .properties

BIOS Features

3-9

Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.