Interrupt coalescing has been set

Change will take effect after system reset

Note: The system must be power cycled for the changes to take effect. It is not sufficient to execute the reset-allcommand.

3.1.5.6 Set Fibre Channel Link Speed

There are two modes of operation for Fibre Channel, 1 Gbit/s and

2 Gbit/s. It is important to match the speed of the port with the speed of the loop or fabric to which the port is attached.

LSI Logic has implemented auto-negotiation on the 2 Gbit/s capable Fusion-MP devices. If you are experiencing difficulty with the auto negotiate algorithm on your fabric or loop, or you wish to manually set or show the link speed for the adapter, use the following procedure:

Select the port or adapter shown (use the port name your system assigns):

ok select /pci@8,700000/IntraServer,fc@1

ok show-link-speed

Link speed selected is 1 Gbaud

Current link speed is 1 Gbaud

ok set-link-speed<- command with no arguments prints help

usage is <link-speed> set-link-speed

ok a set-link-speed

Link speed selected is autobaud

Link speed has been set

Change will take effect after system power cycle

ok show-link-speed

Link speed selected is autobaud

Current link speed is 1 Gbaud

Note: The system must be power cycled for the changes to take effect. It is not sufficient to execute the reset-allcommand.

3-12

BIOS Features

Copyright © 2001, 2002 by LSI Logic Corporation. All rights reserved.