Quick Setup
Follow these steps to quickly set up Magellan with the required settings for a basic security installation.
For more
1.Getting Started
1.After powering up for the first time, press [START] to access the Installer Menu.
2.The first menu option will appear. Press [NEXT] to go to the “User Profile” menu.
2.User Programming
1.From the “User Profile” menu, press [OK].
2.Select which user you wish to add by pressing [NEXT]. When the desired user appears, press [OK] and follow the menus to set:
-Access Code
-User Label
-Remote Control
When you are done the next menu option will appear (see Central Station Reporting below).
For more
3.Central Station Reporting
1.From the “Communicator” menu, press [OK].
2.Press [OK] and follow the menus to set:
-Telephone numbers
-Account Number
-Report Format
When you are done the next menu option will appear. Press [NEXT] until you see the “Zone Profile” menu or press the [6] key to immediately access the “Zone Profile” menu.
4.Adding and Programming Zones
1.From the “Zone Profile” menu, press [OK].
2.Select which zone you wish to add by pressing [NEXT] and press [OK] when the desired zone number appears.
3.Press the tamper switch on the transmitter you wish to assign to the selected zone. Follow the menus to set:
-Zone Label
-Zone Type
-Other Zones
When you are done the next menu option will appear. Press
[NEXT] until you see the “System Test” menu or press the [5] key to immediately access the “System Test” menu.
For more
5.Testing the Magellan System
1.From the “System Test” menu, press [OK].
2.Select which test you wish to perform by pressing [NEXT] and press [OK] when the desired test appears. The following tests can be performed:
-Zone tests
-Remote control tests
-Reporting tests
-Hardware tests
WARNING! When testing the hardware, the speaker and sirens will also be tested. Avoid close proximity to the Magellan console when performing the hardware test to avoid any damage to your hearing.
4 | Reference & Installation Manual |
