!I Vour TV remote can be set to
-• work your VCR or Cable Converter by what is called the SEARCH method.
lf the "REMOTE CODE" number method shown in the previous
| section did not set your remote to |
| work your VCR or Converter, then |
| fi_llow the easy steps listed below. |
| Please read through steps |
| before beginning. |
<_ | Press the POWER button on |
| unit ON. |
| the VCR or Converter to turn the |
<_ | Stand at least six feet away |
| from the front of the VCR or |
| Converter. |
| Point the remote toward the unit. |
| HOLD DOWN the SURF and |
| the desired System (VCR or |
| |
| same time. KEEP HOLDING |
| B U'I_ONS DOWN. |
| Watch the Channel Indicator |
| on the unit. |
| Channel Numbers will SCAN UP |
| when the unit has been identified. |
| This may take up to two minutes. |
| Release the SURF and System |
| (VCR or CBL) buttons as soon |
| as channel numbers start to scan |
| up. The code has been identified |
| and the remote is ready to operate |
| with the VCR or Converter. |
| O |
Remember, a minute or two can seem very long, but
the code should be located within two minutes.
Don't let the VCR scan up more than five channels. If you do the
remote may pass up the right code and another two minute search
cycle will have to be repeated.
"If no channel change happens
¢¢ithintwo minutes, repeat steps 1-
not occur, the remote will not work
4with. Shouldthe desireda channelunit. change still
CABLE CONVERTER
o91
09 . f
Six Feet
(minimum)
1
