For most homes this step would not be needed but for your
information:
Up to 9 different remote locator address codes can be set on which the TV can send out its "homing" signal.
This is done in case there is more than one TV (with a remote Iocator) oresent, and you want only one specific remote to be signaled when the TV is turned ON.*
To set a Locator Address Code:
<With "IV turned ON, press the TV
System button first and then the
LOCATOR CODE button on the
remote.
You will need a pencil or pen to press the recessed button.
The TV shows the present Remote
Locator Code.
>Press any number button
Code.
The remote will beep to let you know it has received the new Locator Code and then return to its normal operating
mode.10
Remember, if batteries are replaced the Locator Code will need to be reentered.
When setting the Locator Code if any button, other than the number buttons, are pressed the remote will return to its normal operation mode.
*For owners who live in an apartment I (townhouse or condominium)
complex, this task may be necessary since the remote Iocator's signal can be sent and detected directly through adjoining walls.
