3 |
Section 1 Software Installation
The Genius protocol driver is copied to your computer as part of the standard PCS installation (PCS version 1.8 or later). The PCS should be installed according to the instructions in the following sections.
Calling the Setup Program
Insert the PCS distribution diskette into the appropriate floppy disk drive. If you are using the two 3 1/2” diskettes, install the #1 disk first (the system will prompt you when it is time to insert disk #2).
Depending on the floppy drive designation (a or b), type one of the following commands at the DOS prompt, then press the ↵ (Enter) key:
C:\>a:setup
or
C:\>b:setup
After you press ↵ , the setup program is called and the menu for language selection appears on the screen.
Language Selection
The Language Selection menu is used to select the language (English or German/Deutsch) in which you wish to configure the PCS during the installation procedure. This language is used as the default selection for the PCS.
Press the function key that corresponds to the desired language. When it has been selected, the Install Program menu is displayed on the screen.
3 - 2 | PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 |
