GE Monogram GFK-1115 manual INPUT#1

6

●

●

●

●

●

●

●

Change the field parameters as follows:

Position:	10,3
Number of Digits:	5
Places after the dec. point:	0
Character Size:	1
Field Width:	5
Destination Tagname:	INPUT#1
Tagname for Completion:
Value for Completion:	0
Up/Down Input? (Y/N):	No
Locking Active? (Y/N):	Yes
Scaling ? (Y/N)	No

Press F2 Locking. The following window appears on the screen:

For the first parameter Tagname for Locking Value, enter the address of the input field for the password (PASSWORD).

The second parameter Input Locked if determines the value at which the input field is locked or enabled for entries. Move the cursor to this line and press the ↵ key. This calls a selection window. Select the entry Locking Value == 0. This causes the input field to be locked if the locking value is 0 (an invalid password is entered).

The third parameter is not evaluated if the locking condition Locking Value == 0 is selected.

Press F4 Accept to close the Input Locking Configuration window.

Now press F4 Accept to close the Input Word (unsigned) window. The field is then shown in the actual cursor position.

GFK-1115 Chapter 6 Demo Project 6 - 43