B

Errors While Working in PCS

When the PCS is running, error messages are either displayed in the bottom line of the screen (the function key line) or in the current window.

Faults running PCS!

Check that the following condition is met:

FILES and BUFFERS in the CONFIG.SYS file should be set to at least the following values:

BUFFERS = 10

FILES = 40

During installation, the SETUP program makes these settings automatically, but only if you responded positively by pressing Y during the installation process. If the BUFFERS and FILES values in the CONFIG.SYS file are smaller, change them to the above values before trying to run the PCS again.

Invalid Project Name

This error message appears in the last line if a new project is assigned a name that already exists. Either change the new project's name or delete the existing project with the same name.

<File name> cannot be written

When entering project names or saving pictures, text groups, or key definitions, filenames must meet the following conditions:

Maximum length of the filename: 8 characters

Only standard MS-DOS characters are allowed. Characters such as ".*?,;.:" or the space character are not permitted.

<File name> cannot be read

This error message appears if a non-existent filename is entered while trying to load a project or picture.

If no filename is entered and [ENTER] is pressed, all existing project or picture names are listed in a selection window. By using the cursor keys to highlight a filename, the desired project/picture can be selected and loaded.

B - 4

PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995

GFK-1115

Page 170
Image 170
GE Monogram GFK-1115 manual Errors While Working in PCS, Faults running PCS