Manhattan Computer Products DS 100 manual Tuning

The set-up screen shows the strength of the freesat signal received from the satellite dish. If the signal strength is below 50%, you should check the satellite dish connection at the back of the receiver (switch the receiver off and reconnect the cable if necessary). If the connection is OK, consult your dealer or installer.

When the signal strength shown on the set-up screen is 50% or more, you can tune the receiver in.

TUNING IN

Because this is the first time that the receiver has been used, there are no channels stored in it’s memory. The receiver will automatically find and store channels.

Press the button on the remote control to search for the ‘Network ID’ and ‘Transport ID’.

HINT: The Network ID and Transport ID are in the freesat signal and are used to allow the receiver to identify the satellite dish and freesat network, to make sure the dish is receiving the correct satellite signals.

When the Network ID and Transport ID have been found and displayed, press the button on the remote control to display the following postcode screen.

15