Marantz DV4001 manual Connecting Up, Easy setup

2 Connecting Up

Easy setup

This easy setup is the minimum set of connections you need to start watching DVD-Video discs. Both sound and picture are fed directly to your TV using the supplied audio/video cables. For other possible connections, see pages 11 and 12.

Important

•Before making or changing any rear panel connections, make sure that all components are switched off and unplugged from the wall outlet.

•While a connected component is turned on, do not unplug the power cord of this DVD player from the wall outlet. The speaker may be damaged.

2	Connect to a pair of stereo
	audio inputs on your TV using

the supplied Audio/Video cable.

1	Connect to a composite video	RS-232C terminal/
	input on your TV using the	FLASHER IN
	supplied Audio/Video cable.	Control terminal for use by
		custom installers.

	CR	Y		EXT. INT.		IN
	L		VIDEO
				FLASHER		RS-232C
				IN
	R		S1			OUT
					REMOTE CONTROL
HDMI	ANALOG COAX.	CB
Ver 1.0	AUDIO	COMPONENT	A/V EUROCONNECTOR			AC IN

See Note:	EXT. INT.	3	Plug into a standard
Remote Switch			AC wall outlet.

Connecting audio/video cables

Be sure to insert each plug fully for the best connection. The plugs and jacks are color-coded to make connection easier.

Connecting system control cables

By connecting this DVD player to another Marantz audio component using a supplied system control cable, you can remotely operate the components as a single system.

•When connecting to a component with a remote sensor, be sure to connect the REMOTE CONTROL IN jack of this DVD player to

the REMOTE CONTROL OUT jack of the component with the remote sensor.

•When connecting to component which is not equipped with a remote sensor, be sure to connect the component to the REMOTE CONTROL OUT jack of this DVD player.

Note

•When connecting to a standard TV, select

4:3 LETTER - BOX or 4:3 PAN SCAN in the TV Aspect setting (see page 38).

•Connect the video output of the player directly to your TV. Because the player is designed to support an Analog Protection System copy card, there are cases when proper playback will be not be possible if the player is connected to the TV through a VCR and images are recorded and played on the VCR.

•The player’s video output and S1 output are not be progressive.

•Remote switch

When using this DVD player independently, set this switch to INT. (INTERNAL). When using this DVD player in a system with a Marantz receiver equipped with a remote sensor, set the switch to EXT. (EXTERNAL).

•Flasher Input

This is used when controlling components from different rooms with a keypad or other input device. Set the remote switch to EXT. (EXTERNAL) when using a flasher input.

10