NAMESAND FUNCTIONS |
ENGLISH
BASIC CONNECTIONS
CONNECTING THE ANTENNAS
CONNECTING OF AC POWER CABLE
BASIC OPERATION
AMP OPERATION
CONNECTIONS | BASIC |
OPERATION | BASIC |
CONNECTING THE SUPPLIED ANTENNAS
The supplied antennas are for indoor use only.
ASSEMBLING THE AM LOOP ANTENNA
Insertting the tabs into the base as shown.
CONNECTING THE AM ANTENNA CABLE
1. Plug the supplied AC power cable to the AC IN socket on the rear panel of the main unit.
AC IN
TURNING ON THE UNIT
Black White
Press and hold | Insert wire | Release |
1. Connect the AC power cable to the wall |
outlet. |
ADVANCED CONNECTIONS |
SETUP |
GND
AM
Notes
•During use, extend the FM antenna and move it in various directions until the clearest sound is received. Fix it with push pins or similar implements in that cause the least amount of distortion.
•Set in the direction and position it to where you receive the clearest sound. Put it as far away as possible from the unit, televisions,speaker cables and power cable.
CONNECTING AN OUTDOOR ANTENNAS
If you experience poor reception quality, an outdoor antenna may improve the quality.
Keep the antenna from noise sources (neon signes, busy roads, power lines, transformers, etc)
2. Plug the power cable into an AC outlet. | 2. Turn the power on to other units connected |
|
to this unit.
3. Press the POWER ON/STANDBY button of this unit. Every time the button is pressed, the power to this unit toggles between on and standby.
To activate power using the remote controller, press the AMP button, followed by the ON button and SOURCE ON/OFF button of the remote controller.
ADVANCED OPERATION |
TROUBLESHOOTING |
FM External Antenna
AM Loop Antenna
Black White
GND
AM
FM
(75Ω)
AM External
Antenna
16 to 32ft (5 to 10m)
OTHERS |
Ground
Notes
•Do not remove the AM loop antenna.
•Do not connect the supplied FM antenna.
•The GND terminal on this unit does not function as a safety ground.
12
