| Contents | Connections | Playback | Settings | Tips | Appendix | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Symptom |
|
|
| Cause / Solution |
|
| Page |
| Dolby PLg mode or DTS | 0 | It cannot be selected when “Speaker Config.” - “Center” or “Surround” is set for “None”. |
| 187 | |||
| Neo:6 mode cannot be |
|
|
|
|
| ||
| 0 | Dolby PLg or DTS Neo:6 cannot be selected when using headphones. |
|
| - | |||
| selected. |
|
|
|
|
|
|
|
| Audyssey MultEQ®, | 0 | These cannot be selected when you have not performed Audyssey® Setup. |
|
| 176 | ||
| Audyssey Dynamic EQ® |
|
|
|
|
| ||
| 0 | Switch to a sound mode other than “Direct” or “Pure Direct”. |
|
| 118 | |||
| and Audyssey Dynamic |
|
|
|
|
|
|
|
| 0 | These cannot be selected when using the headphones. |
|
| - | |||
| Volume® cannot be |
|
| |||||
| selected. |
|
|
|
|
|
|
|
| 0 | Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of |
| 154 | ||||
| selected. |
| multichannel signals such as Dolby Digital or DTS surround, |
|
| |||
|
| 0 | Switch to a sound mode other than “Direct” or “Pure Direct”. |
|
| 118 | ||
| No sound is output when | 0 | Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) |
| - | |||
| using ZONE2. |
| cannot be played back. Use analog connections. |
|
|
| ||
|
| 0 | When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the |
| - | |||
|
|
| Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m. |
|
|
|
Front panel | Display | Rear panel | 220 | Remote | Index |