Marantz NR1605 Wireless LAN, Contents, Connections, Playback, Settings, Tips, Appendix, Display

Contents Connections Playback Settings Tips Appendix

Wireless LAN

When connecting to a wireless LAN network, stand the rod antenna for wireless LAN/Bluetooth connection upright on the rear panel.

See “Wi-Fi Setup” (v p. 195) on how to connect to a wireless LAN router.

Internet

Modem

To WAN side

Router with access point

0When using this unit, we recommend you use a router equipped with the following functions:

0Built-in DHCP server

This function automatically assigns IP addresses on the LAN.

0Built-in 100BASE-TX switch

When connecting multiple devices, we recommend a switching hub with a speed of 100 Mbps or greater.

0Only use a shielded STP or ScTP LAN cable (readily available at electronics stores). (CAT-5 or greater recommended)

0The normal shielded-type LAN cable is recommended.

If a flat-type cable or unshielded-type cable is used, other devices could be affected by noise.

0When using a router that supports the WPS（Wi-Fi Protected Setup）function, Wi- Fi connection can be carried out easily.

0When using this unit connected to a network with no DHCP function, configure the IP address, etc. in “Network” (v p. 194).

NOTE

0The types of routers that can be used depend on the ISP. Contact your ISP or a computer shop for details.

0This unit is not compatible with PPPoE. A PPPoE compatible router is required if your contracted line is not set using PPPoE.

0Do not connect an NETWORK connector directly to the LAN port / Ethernet connector on your computer.

0Various online services may be discontinued without prior notice.

Front panel Display Rear panel 51 Remote Index