Contents | Connections | Playback | Settings | Tips | Appendix |
oDesired sound does not come out
Symptom |
|
|
| Cause / Solution |
| Page | |
The volume does not | 0 | The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. | 155 | ||||
increase. |
|
|
| ||||
0 | Appropriate volume correction processing is performed according to the input audio format and settings, | - | |||||
|
| so the volume may not reach the upper limit. |
|
|
| ||
No sound comes out with | 0 | Check the connection of the HDMI connectors. |
|
| 39 | ||
the HDMI connection. |
|
|
| ||||
0 | When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output | 163 | |||||
|
| from the TV, set “TV”. |
|
|
|
|
|
| 0 | When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV. | 128 | ||||
No sound comes out of a | 0 | Check that speaker cables are properly connected. |
|
| 28 | ||
specific speaker. |
|
|
| ||||
0 | Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. | 187 | |||||
| 0 | Check the “Assign Mode” setting in the menu. |
|
| 186 | ||
| 0 | When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and | - | ||||
|
| subwoofer. |
|
|
|
|
|
No sound is produced from | 0 | Check the subwoofer connections. |
|
|
| 29 | |
subwoofer. |
|
|
|
|
|
| |
0 | Turn on the subwoofer’s power. |
|
|
| - | ||
| 0 | Set “Speaker Config.” – “Subwoofer” on the menu to “Yes”. |
| 187 | |||
| 0 | When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the | 187 | ||||
|
| sound mode, no sound may be output from the subwoofer. |
|
| |||
| 0 | When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the | 192 | ||||
|
| subwoofer. |
|
|
|
|
|
| 0 | You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. | 192 | ||||
DTS sound is not output. | 0 | Check that the digital audio output setting on the connected device is set to “DTS”. |
| - | |||
| 0 | Set “Decode Mode” on the menu to “Auto” or “DTS”. |
|
| 175 | ||
Dolby TrueHD, | 0 | Make HDMI connections. |
|
|
| 44 | |
Dolby Digital Plus audio is |
|
|
| ||||
0 | Check the digital audio output setting on the connected device. On some devices, “PCM” is set by | - | |||||
not output. |
| default. |
|
|
|
|
|
Front panel |
| Display | Rear panel | 219 | Remote | Index |
|