ENGLISH
•If while editing macros no buttons are pressed for approximately 1 minute, the remote controller will automatically return to normal mode, and no macro changes will be programmed in the memory.
4.When you are finished editing macros, use a ballpoint pen or other sharp point to press the MACRO button x. END will be displayed on LCD A and the display will return to normal.
Note:
When the Jog Dial m has been programmed in a macro, changing the function immediately before causes the jog commands immediately after to be automatically changed to the commands of the new function. (The commands are changed to the commands on the same page number of the new function.)
USING MACROS
The following procedure will show how to use the function buttons for which you have programmed macros.
1.Press the Function button , for the desired macro for 3 seconds. MACRO is displayed on LCD A for approximately 1
second, after which the number of steps in the macro is displayed on LCD C.
C D | DVD | ||
DSS | T V | VCR | AUX |
L D | TUNER | TAPE | AMP |
CLEAR MEMO 
GUIDE MUTE
AUTO DOLBY THX DTS HALL
•The remote controller will do nothing if no macros are programmed. The macro steps are executed in order and the names of their buttons are
displayed on the LCD. Also, the step numbers displayed on LCD c disappear as each step is executed.
2.After all macro commands have been transmitted, the remote controller returns to normal mode.
•To cancel the transmission of a
programmed macro, use the v Cursor button ⁄0(STOP button).
24
