USING THE CLONE MODE
All the codes which have been programmed can be copied altogether into another RC1200 remote controller by a few simple operations. (Macros and the
Note:
The clone function cannot be used for copying unless the same model (RC1200) is used for the remote controllers at the sending and receiving ends.
1.Place the light sensor (in the head section) of the remote controller at the receiving end about 5 centimeters (2 inches) away from and directly in front of the transmitter (also in the head section) of the remote controller at the sending end.
CONTROL RC 1200 MACRO MODE | LEARNING REMOTE | ON ON / OFF OFF | SOURCE | POWER | 5cm | POWER | SOURCE | ON ON / OFF OFF | LEARNING REMOTE | CONTROL RC 1200 MACRO MODE |
2.Use a ballpoint pen or other sharp point to press the MODE button z on the sending unit to call up the CLONE and TX displays. CLONE appears at LCD A and TX at LCD B.
ENGLISH
POWER
SOURCE
ON ON / OFF OFF
LEARNING REMOTE
CONTROL RC 1200 MACRO MODE
29
