ENGLISH
To go ahead with the clearing operation, release the buttons, and press the OK Cursor button ⁄0.
Once the data is cleared, the codes are either returned to their original display or left empty. LCD is similarly returned to its factory preset or left empty. All the macro programs are also cleared.
•To cancel the memory clearing
operation, do not press the OK Cursor button ⁄0and simply touch any other button.
After the OK Cursor button ⁄0is pressed, clearing the entire memory will take approximately 10 seconds.
PROGRAMMING MACROS
Macros make it possible to use a single function button to perform more complex series of operations that would normally require pressing several buttons. A single button can be programmed to perform up to 10 steps in sequence. A typical example of such a series might be as follows:
• Turn the main amplifier power ON → Switch the function to DVD → Set the Surround Mode to Pro Logic → Switch the TV to video input → Set the DVD player to PLAY.
•No signals may be transmitted during macro programming.
•The various steps that make up a macro are set initially to be sent one after another in 1 second intervals, however these intervals may be shortened to as little as 0.5 seconds or lengthened to as much as 5 seconds using the Setup mode.
•In the macro mode, the number of steps the macro contains is displayed on LCD c. Macros may be programmed for each of the 11 function buttons, from LD to AMP.
1.Use a ballpoint pen or other sharp point to press the MACRO button x until the MACRO and LEARN indicators are displayed blinking on the LCD.
| POWER |
| |
| SOURCE |
| |
ON | ON / OFF | OFF | |
LEARNING REMOTE |
|
| |
CONTROL RC 1200 | MACRO | MODE | |
|
|
| 20 |
