ENGLISH
3.Use a ballpoint pen or other sharp point to press the MODE button z on the
receiving unit to call up the CLONE and RX displays. CLONE appears at LCD A and RX at LCD B.
POWER
SOURCE
ON ON / OFF OFF
LEARNING REMOTE
CONTROL RC 1200 MACRO MODE
4.Press the OK Cursor button ⁄0on the receiving unit.
5.Press the OK Cursor button ⁄0on the sending unit. The copying operation is now commenced.
CH 
OK 
VOL
6.During the copying operation, the bar displays at LCD C on both units start moving from left to right. After the entire
bar displays have lighted, the display at LCD B on the receiving unit changes to RX OK and the LCD display on the sending unit changes to TX OK. Copying is now completed.
•Do not touch either of the remote controllers during the copying operation. Doing so may cause copying to fail.
•When copying has failed at an interim point, RX NG will appear on the LCD display of the receiving unit. Check steps 1 to 5, and repeat.
30
