ENGLISH
1Place the receiver sensor of the receiving remote control (top) so that it is facing the transmitter of the transmitting remote control (top) at a distance of about 5 cm (2 inches).
2Hold down the M button r of the transmitting remote control for three seconds or more.
The menu is displayed.
3Press the > button y to display the fourth page CLONE menu.
4Press the D3 (TX) direct button t.
The transmitting side is now ready.
5Hold down the M button r of the receiving remote control for three seconds or more.
6Press the > button y to display the fourth page CLONE menu.
7Press the D2
8Press the source button !4to be copied.
The receiving side is now ready.
The name of the source which was pressed is displayed on the LCD.
•Each time the source button is pressed, the name is displayed on the LCD.
9Press the OK cursor button @0on the receiving remote control.
10Press the OK cursor button @0on the transmitting remote control.
When copying is started, the bar indicators on both LCDs start to move from the left to the right.
•When the copying operation is completed, TX OK is displayed on the LCD of the transmitting remote control, and RX OK is displayed on the LCD of the receiving remote control.
•Do not touch either of the remote controls during the copying operation. Doing so could cause copying to fail.
•If the copying fails in the middle of the copying process, ERROR is displayed on the remote control.
Check and perform steps 1 to 7 again.
11Once copying is completed, press the M button r on both remote controls.
40
RC1400N 01 ENG | Page 40 | 03.10.6, 4:19 PM Adobe PageMaker 6.5J/PPC |
