3Press the > button y to display the fourth page CLONE menu.
4Press the D3 (TX) direct button t.
The transmitting side is now ready.
5Hold down the M button r of the receiving remote control for three seconds or more.
The menu is displayed.
6Press the > button y to display the fourth page CLONE menu.
7Press the D1 (RX) direct button t.
The receiving side is now ready.
8Press the OK cursor button @0on the receiving remote control.
9Press the OK cursor button @0on the transmitting remote control.
When copying is started, the bar indicators on both LCDs start to move from the left to the right.
•When the copying operation is completed, TX OK is displayed on the LCD of the transmitting remote control, and RX OK is displayed on the LCD of the receiving remote control.
•Do not touch either of the remote controls during the copying operation. Doing so could cause copying to fail.
•If the copying fails in the middle of the copying process, RX ERROR is displayed on the receiving remote control. Check and perform steps 1 to 7 again.
•Copying takes about three minutes to complete when the transmitting remote control has been programmed to 100% capacity.
10Once copying is completed, press the M button r on both remote controls.
ENGLISH
Copying by Source
The 12 sources can be copied on a source by source basis. You can select from up to 12 source types.
<Receiving remote control>
6 | 7 | 8 | |||
|
|
| LEARN |
|
|
PAGE 1 2 3 4
1 2 3 4
PAGE 1 2 3 4
39
RC1400N 01 ENG | Page 39 | 03.10.6, 4:19 PM Adobe PageMaker 6.5J/PPC |
