1Hold down the M button r for three seconds or more.
The menu is displayed.
2Press the D2 (LEARN) direct button t.
The LEARN setting (LEARN) is displayed. The
LEARN indicator then blinks.
3Press the DVD source button !4.
4Press the 
(PLAY) !3button.
The LEARN indicator blinks, and then displays to indicate that learning is ready.
5Place the receiver sensor of the remote control (top) so that it is facing the transmitter of the DVD remote control (top) at a distance of about 5 cm (2 inches).
6Press and hold down the 
(PLAY) button of the transmitting DVD remote control, and check that OK is displayed on the LCD.
The remote control has finished learning when OK is displayed on the LCD.
If ERROR is displayed on the LCD, some error has prevented the command from being learned. If this happens, repeat the procedure for steps 4 and 5.
In some rare cases, ERROR may be displayed repeatedly during the learning operation. In this case, the transmitting remote control may have special signal codes. These codes cannot be learned by this remote control.
7Follow the same procedure to make the remote control learn the other buttons.
8Repeat the procedure in steps 3 to 6 to have the remote control learn the signal codes from a TV, CD player, or other AV equipment.
•When no buttons are pressed for approximately one minute during the learning operation, the remote control automatically returns to USE mode.
•When programming the source buttons, switch to the source in step 3, and then press the source button again.
9When you have finished programming the codes for each button, press the M button r.
The USE indicator is displayed on the LCD, and the newly stored codes can be used.
•If FULL is displayed on the LCD, the memory cannot hold any more learned codes in LEARN mode.
ENGLISH
19
RC1400N 01 ENG | Page 19 | 03.10.6, 4:17 PM Adobe PageMaker 6.5J/PPC |
