
8To set the manufacturer number for another source device, repeat the procedure in steps 4 to 6.
9After the settings are completed, press the M button r.
10Press the buttons on the remote control to check that the DVD can be operated correctly.
Setting Equipment Not Appearing in Manufacturer Number List
Use the sequence function to set equipment not appearing in the manufacturer number list. You may still be unable to set some equipment even when using the sequence function. In this case, the remote control can be programmed with codes individually.
In the sequence function, the power ON/OFF codes are transmitted by pressing the remote control buttons in order.
If the power for the equipment is left on, hold down the button until the equipment is turned off, and then release. This completes the setting.
This example shows how to set a DVD player.
4 | 5 | 7 |
ENGLISH
LEARN
1 2
LEARN
1 2
LEARN
1 2
1Turn on the power of the DVD player.
2Hold down the M button r for three seconds or more.
The menu is displayed.
3Press the D1 (PRESET) direct button t.
The Preset setting
4Press the DVD source button !4.
5Hold down the CH+ or CH– button !9for one second or more.
6Press the CH+ button !9repeatedly in the interval for one second.
The signal is transmitted, and the display cycles through the code number.
Press the CH– button to go back to a number screen.
7Release the button once the DVD player turns off.
8Press the OK cursor button @0.
17
RC1400N 01 ENG | Page 17 | 03.10.6, 4:17 PM Adobe PageMaker 6.5J/PPC |