Troubleshooting
User Guide |
nInsert delays to allow devices to start up properly (see page 26).
nCheck if you have included inactive buttons in your macro.
nCheck if you haven’t reprogrammed the buttons. Macros do not store commands, they store button locations. If you reteach a button, the macro will execute the newly learned code, not the code that you taught to the original button.
The TV goes blank or the input source changes
nThe Device menu item might be programmed to switch the input source. Select the device without issuing IR (p9)
The RC9200/5200 won’t edit, label or delete commands
nIf the label locked appears on the RC9200/5200 icon, the device control panels have been locked to prevent unwanted changes. You cannot modify or delete commands for this device.
nMake sure your devices are positioned as shown on page 28. Avoid programming the RC9200/5200 under bright fluorescent light, it might affect the infrared signals.
nMake sure the button you want to edit has a border. Text frames cannot be programmed with commands.
The RC9200/5200 won’t switch modes
nWhen the batteries are low, the RC9200/5200 prevents you from switching to customizing modes so that no customization can get lost. Recharge the battery pack (see page 3).
The RC9200/5200 is low on memory
nThe RC9200/5200 displays a message to clean up the memory. The RC9200/5200 will do this by permanently removing devices and macro and timer groups you have deleted (see page 40).
Warning Cleaning up memory can take 10 minutes or longer. Never remove batteries during the
The configuration file is corrupted
nWhen this very unlikely event occurs, you have to use the Revert button on the second setup panel (see page 14). All your customized commands, devices, and macros will be lost, and you will have to reprogram your Remote Control. Should you
53
