Installing Matrox Meteor-II /Camera Link 17
Caution Some computers have a large, black-ridged heat sink that prevents boards from
using most PCI board slots. Your Matrox Meteor-II must not touch this heat sink.
Therefore, choose a slot where the board completely avoids it.
3. If present, remove the blank metal plate located at the back of the selected slot.
Keep the removed screw; you will need it to fasten the Matrox Meteor-II board.
4. Carefully position Matrox Meteor-II in the selected PCI slot as illustrated below.
If you are using a tower computer, orient the board to suit the board slots in your
computer.
5. Once perfectly aligned with an empty slot, press the board firmly but carefully
into the connector.
6. Anchor the board by replacing the screw that you removed.
7. Follow the steps below to install the expanded adapter bracket:
a. If present, remove the blank metal plate located at the back of a slot next to the
Matrox Meteor-II /Camera Link board; do not discard this screw.
b. Install the expanded adapter bracket and fasten it with the screw you just
removed.
SCREW
METAL
PLATE
32-BIT PCI BOARD SLOT
PCI form factor
MATROX METEOR-II