Maxxsonics MAXX-2400HD Access To Components, Gigabit Ethernet Indicators, Opening the Front Panel

Gigabit Ethernet Indicators

The Gigabit Network Port card has the following indicator lights:

Label	Indication	Meaning
ACT/LNK	Green on	The port is connected to a valid link partner
	Green flashing	Data activity
(Left)
	Off	No link
10=OFF	Off	10 Mb/sec
100=GREEN	Green	100 Mb/sec
1000=YELLOW	Yellow	1000 Mb/sec
(Right)

Access To Components

Be certain to shut down the server and disconnect the power cord before opening the unit for service.

The following sections provide instruction on disassembly and re-assembly for maintenance.

Opening the Front Panel

The front panel is easily opened for access to the twelve disk drives, or for removing the server from an equipment rack. Using a coin or a flat-blade screwdriver, unscrew the two large panel fasteners on the left and right sides of the face panel. Pull outward and down to remove cover.

To re-install the front panel, verify that all wires are within the chassis, then place the front panel into position and tighten the front panel access screws just enough to be snug.

Removing the Top Cover

Press down on the two latch buttons, slide the cover toward the rear of the chassis, then lift.

MAXX-2400HD Owner’s Manual Page 107