Maxxsonics MAXX-2400HD manual Programming GPIO Outputs

Programming GPIO Outputs

The MAXX-2400HD has twelve General Purpose Outputs, referred to as GPO 1 through 12. Each can be programmed to go active on the selected channel when one of the following events occurs:

IDLE	Transport returns to idle
PAUSED	Transport is paused
STOPPED	Transport is stopped
PLAYING	Transport is playing
RECORDING	Transport is recording
RAID System Fault	RAID or System Fault
NO GENLOCK	No genlock
NO VIDEO INPUT	No video at the selected input
PLAYLIST	Control GPO via playlist

To program a GPO output, select EDIT->CONFIGURE->GPO. The screen of Figure 16 is displayed. GPO 1 through 12 are triggerable outputs. The checkboxes to the right of each selection represent channel 1, 2, 3 and 4. GPO 9 is shown with the trigger option pulldown expanded.

1.To activate one of the GPO, pulldown the event menu and select which event will activate the GPO.

2.Select an associated channel where applicable by checking the channel checkbox.

3.Click APPLY to activate.

Figure 16 - GPO Configuration Screen

Page 52 MAXX-2400HD Owner’s Manual