Removal Installation | Mazda Mazda2_8BL3-EA-10E

Maintenance and Care

3.Turn the screws and the center section of the plastic retainers counterclockwise and remove them, then partially peel back the mudguard.

Removal

4.Turn the socket and bulb assembly counterclockwise and remove it.

5.Disconnect the bulb from the socket.

Side turn signal lights

1.Make sure the ignition is switched off and the headlight switch is off.

2.Slide the unit as shown in the figure to remove it.

3.Detach the electrical connector from the unit by pulling it outward.

6.Install the new bulb in the reverse order of removal.

4.Install the new side turn signal unit in the reverse order of removal.

NOTE

Bulb replacement is not possible because it is built into the unit. Replace the unit.

8-36