MPH2410.O/M.QXD 3/7/03 9:35 AM Page 6
INSTALLATION INSTRUCTIONS
1.Carefully unpack and remove your unit from the box.
2.Make sure all of the following items have been included:
• | Base Unit |
| (AC120V, 60Hz/DC9V, 300mA) |
• | Handset Unit | • 2 Telephone Cords (Short and Long) | |
• Rechargeable | • | Belt Clip | |
| (3.6V, 600mAH) | • | Mounting Bracket with Screws |
•AC Adapter
3.Make sure the Rechargeable Battery is installed or install the Rechargeable Battery as described on page 9.
PLEASE REFER TO FIGURE 1 FOR STEPS 4 THROUGH 7:
Base | AC |
| |
| Outlet |
DC 9V Jack | AC | |
DC | ||
Adaptor | ||
Adaptor Plug | ||
|
Figure 1
4.Slide the TONE/PULSE switch on the side of the Base unit to TONE or PULSE to match the service provided on your telephone line. If you are not sure of your service, please contact your telephone company. The factory preset position for this switch is TONE.
5.Connect one end of the telephone line cord into the TEL LINE jack on the rear of the base unit and the other end into a modular telephone jack.
6.Insert the small plug at the end of the DC adapter into the DC 9V jack located at the rear of the base unit.
NOTE: Use only the
8. | If desired, install the belt clip by inserting the belt clip | Belt Clip Hook |
| hook into the matching slots at the top side of the |
|
| handset as shown in figure 2. Slide the other hook until |
|
| it locks into place from the opposite side of the handset. |
|
9. | If desired mount on a wall as described on the next |
|
| two pages. |
|
Figure 2
6
