Memorex MPH2410 Wall Mounting the Unit no Standard Wall Jack, Uninstalling the Wall Mount Bracket

MPH2410.O/M.QXD 3/7/03 9:35 AM Page 8

INSTALLATION INSTRUCTIONS (CONTINUED)

WALL MOUNTING THE UNIT (NO STANDARD WALL JACK)

1.Drill two holes with a vertical distance between the two marked positions of 3 15/16" (100mm).

2.Drive a screw into each of the holes. Tighten them to the end of the screw

lines, only leaving the smooth part of the screw head outside the wall.

3.Install the wall mount bracket into the base unit as previously discussed in Figures 3-6 on the previous page.

4.Hang the unit onto the screws, then slide it down firmly to fasten the base securely, as shown in Figure 8.

Base

(Side View)

Screws

Wall

Mount

Bracket

Figure 8

UNINSTALLING THE WALL MOUNT

BRACKET

To remove the wall mount bracket from the base unit, pull it back as shown in Figure 9.

Figure 9

HEADSET CONNECTION

One of the special features of your phone is that your handset could utilize a headset (not included) for hands-free communication. Insert the small plug at the end of your headset cord to the headset jack at the side of the handset. Follow the procedures discussed in “Placing a Call” and “Receiving a Call” to place and receive a call.

NOTE: The headset jack of your cordless telephone is compatible with 2.5 mm headset plugs only. When you plug in the headset into the headset jack, it automatically mutes the microphone and speaker of the handset. Unplug the headset to return the handset to normal use.

8