MPH2410.O/M.QXD 3/7/03 9:35 AM Page 7
INSTALLATION INSTRUCTIONS (CONTINUED)
WALL MOUNTING THE UNIT (STANDARD WALL JACK)
Follow the instructions below to install the base onto a standard telephone wall jack:
1.Connect the short telephone line cord to the TEL LINE jack on the rear of the base unit.
2.Insert the free end of the short line cord through the hole of the mounting bracket.
3.Insert the hooks of the mounting bracket into the matching slots on the back of the unit as shown in Figure 3. Press the two locks located on the side of the mounting bracket until the locking hooks snap into the inner slots of the base unit as shown in Figure 4.
Figures 3 through 6
4.Press the middle locking hooks of the mounting bracket while pushing the back of the mounting bracket until it snaps to lock as shown in Figure 5.
NOTE: Ensure that the lock guide stays in place on the hole provided on the base unit as shown in Figure 6.
5.Plug the free end of the short line cord into the modular wall jack.
6.Align the upper keyhole on the mounting bracket with the upper stud of the wall plate, so that the opening end of the mounting bracket matches the lower stud, pull the mounting bracket down until it is securely seated as shown in Figure 7.
| Wall |
| Mount |
| Stud |
| Telephone |
| Modular |
| Jack |
Base | Wall |
(Side View) | Mount |
| Stud |
| Wall Mount Bracket |
Figure 7
7
