Juniper Networks J6350, J4350 manual Installing a PIM

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Installing a PIM

CAUTION: Do not hot-swap PIMs. Failure to power off the router before removing or installing a PIM might result in damage to the hardware.

Figure 74: Installing a PIM

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

To verify that the combination of PIMs to be installed in a chassis do not exceed the power and heat capacities for the J4350 or J6350 router, see “Planning for Power Management” on page 112.

To install a PIM (see Figure 74 on page 174):

1.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the Services Router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 251.

2.Press and release the power button to power off the router. Verify that the POWER LED blinks and then turns off.

3.Align the notches in the connector at the rear of the PIM with the notches in the PIM slot in the Services Router, and slide the PIM in until it lodges firmly in the router.

CAUTION: Slide the PIM straight into the slot to avoid damaging the components on the PIM.

4.Tighten the captive screws on each side of the PIM faceplate.

5.Insert the appropriate cables into the cable connectors on the PIM.

174■ Replacing a PIM