Juniper Networks J4350, J6350 manual J2320 and J2350 Avaya VoIP Module Summary

Chapter 3: PIM and VoIP Module Overview

Avaya VoIP modules are described in the following sections:

■Avaya VoIP Module Summary on page 67

■TGM550 Telephony Gateway Module on page 69

■TIM508 Analog Telephony Interface Module on page 73

■TIM510 E1/T1 Telephony Interface Module on page 74

■TIM514 Analog Telephony Interface Module on page 75

■TIM516 Analog Telephony Interface Module on page 76

■TIM518 Analog Telephony Interface Module on page 78

■TIM521 BRI Telephony Interface Module on page 79

Avaya VoIP Module Summary

Table 34 on page 67 and Table 35 on page 68 provide the module names, software release information, slot and port numbers, maximum number allowed on a chassis, and sample interface names (where applicable) for the Avaya VoIP modules.

CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the maximum power and heat capacity of the chassis. If J-series power management is enabled, PIMs that exceed the maximum power and heat capacity remain offline when the chassis is powered on.

On each J-series Services Router with Avaya VoIP, a single TGM550 Telephony

Gateway Module (TGM) and at least one telephony interface module (TIM) is required.

No more than four TIMs of any kind can be installed on a single chassis.

Table 34: J2320 and J2350 Avaya VoIP Module Summary

							Sample Interface
							Name
			Software Release for	Slot and Port		Maximum Number on a
PIM	Also Called		This PIM	Numbering		Chassis	(type-pim/0/port)
TGM550	■	TGM550	JUNOS 8.4 and later	■	J2320—Slots	One (required)	vp-3/0/0
Telephony		Gateway			1 through 3
Gateway		Module		■	J2350—Slots	If more than one	(See the interface
Module	■	TGM550			1 through 5	TGM550 is installed,	naming conventions
						only the one in the	in the J-series Services
						lowest-numbered slot is	Router Basic LAN and
						enabled. For example, if	WAN Access
						TGM550s are installed in	Configuration Guide.)
						slots 2 and 3, only the
						one in slot 2 is enabled.
TIM508	■	TIM508	JUNOS 8.5 and later	■	J2320—Slots	One on J2320	–
Analog		media			1 through 3
Telephony		module		■	J2350—Slots	Three on J2350 (See
Interface	■	TIM508			1 through 5	“Planning for Power
Module						Management”onpage112.)

Avaya VoIP Modules ■ 67