Juniper Networks J6350, J4350 manual AC Power Cord Specifications

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Detachable AC power cords, each 2.5 m (approximately 8 ft) long, are supplied with the Services Router. The appliance coupler at the female end of the cord inserts into the appliance inlet on the faceplate of the AC power supply. The coupler is type C19 as described by International Electrotechnical Commission (IEC) standard 60320.

The plug at the male end of the power cord fits into the power source receptacle that is standard for your geographical location.

NOTE: In North America, AC power cords must not exceed 4.5 m (approximately

14.75ft) in. length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the router are in compliance.

Table 56 on page 110 lists AC power cord specifications provided for each country or region.

Table 56: AC Power Cord Specifications

Country	Electrical Specifications			Plug Standards
Australia	250	VAC, 10 A, 50 Hz		AS/NZ 3112–1993
China	250	VAC, 10 A, 50 Hz		GB2099.1 1996 and GB1002 1996 (CH1-10P)
Europe (except Italy and	250	VAC, 10 A, 50 Hz		CEE (7) VII
United Kingdom)
Italy	250	VAC, 10 A, 50	Hz	CEI 23–16/VII
Japan	125	VAC, 12 A, 50	Hz or 60 Hz	JIS 8303
North America	125	VAC, 10 A, 60	Hz	NEMA 5-15
United Kingdom	250	VAC, 10 A, 50	Hz	BS 1363A

Figure 54 on page 110 illustrates the plug on the power cord for each country or region listed in Table 56 on page 110.

Figure 54: AC Plug Types

NOTE: Power cords and cables must not block access to router components or drape where people might trip on them.

110■ Power Guidelines, Requirements, and Specifications