Juniper Networks J4350, J6350 manual TIM516 Possible Port Configurations, LEDs for TIM516

Chapter 3: PIM and VoIP Module Overview

Figure 45: TIM516 Analog Telephony Interface Module

Analog

ALM
ACT
TIM	516

NEESS	1	— 8
LILIN
S 17 — 24
LINE

g 0 0 3 8 6 6

You can configure TIM516 lines as described in Table 43 on page 77.

Table 43: TIM516 Possible Port Configurations

Possible Analog Telephone (LINE) Line Configurations

Analog tip/ring devices such as single-line telephones with or without LED message-waiting indication

The TIM516 also provides the following features:

■Three ringer loads, the ringer equivalency number for up to 2,000 ft (610 m), for all 16 lines

■Up to 16 simultaneously ringing lines

■Type 1 caller ID and Type 2 caller ID for line lines

■Ring voltage generation for a variety of international frequencies and cadences

For pinouts of cable connectors for the TIM516, see “TIM516 Connector

Pinout” on page 242.

To install or remove an Avaya VoIP module, see “Replacing a PIM” on page 172.

TIM516 LEDs indicate link status and activity. Table 44 on page 77 describes the meaning of the LEDs.

Table 44: LEDs for TIM516

Label	Color	State	Description
ALM	Red	On steadily	Alarm. A TIM516 failure requires
			monitoring or maintenance.
ACT	Yellow	Blinking	Active. A device connected to the
			TIM516 is in use. This situation can
			include a telephone that is off the
			hook.

Avaya VoIP Modules ■ 77