Juniper Networks J6350, J4350 Replacing the Console Port Cable, Replacing a PIM, Removing a PIM

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Table 69: Tools and Parts Required

Tool or Part

Electrostatic bag or antistatic mat

Electrostatic discharge (ESD) grounding wrist strap

Flat-blade screw-blade screwdriver, approximately 1/4 in. (6 mm)

Phillips (+) screwdriver, number 1 and number 2

Components

All

All

PIM

■Chassis cover

■Compact flash

■Crypto Accelerator Module

■DRAM modules

■PIM

■Power system components

Replacing the Console Port Cable

The RJ-45 port labeled CONSOLE on the Services Router's front panel allows you to connect the router to an external management device, such as a laptop or a terminal server. For cable specifications, see “Chassis Console Port Pinouts” on page 234.

To replace the console port cable:

1.Locate an appropriate replacement cable and connector.

2.Plug the Ethernet connector at either end of the cable into the console port on the front panel (see Figure 69 on page 140 and Figure 70 on page 141).

3.Plug the connector at the other end of the cable into the external management device. If you are connecting to a DB-9 serial port, use the provided RJ-45 to DB-9 serial port adapter.

Replacing a PIM

To remove or install field-replaceable Physical Interface Modules (PIMs) in a Services Router, you must first power off the router. This section contains the following topics:

■Removing a PIM on page 172

■Installing a PIM on page 174

Removing a PIM

The PIMs are installed in the front of the Services Router. A PIM weighs less than 1 lb (0.5 kg).

172■ Replacing the Console Port Cable