J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

Installing a J4350 or j6350 Crypto Accelerator Module

To install a Crypto Accelerator Module:

1.Take the following steps if you have not already done so:

a.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the router is disconnected from earth ground. For more information about ESD, see “Preventing Electrostatic Discharge Damage” on page 251.

b.Press and release the power button to power off the Services Router. Wait for the POWER LED to turn off.

c.Unplug the power cord or cable from the power source receptacle.

d.Remove the screws from the sides and the top of the chassis, and slide the cover off the chassis.

2.Locate the Crypto Module socket on the system board (see Figure 98 on page 202). The socket is tipped up at an angle when empty.

3.If a screw and standoff washer are already in place (see Figure 99 on page 203), remove them.

4.Remove the Crypto Module from its electrostatic bag and insert it into the socket.

5.Push the Crypto Module down flat against the main board until the release clips click into place, as shown in Figure 100 on page 203.

6.Insert the standoff washer under the Crypto Module.

7.Insert the screw and tighten it until snug. Do not overtighten.

8.Slide the cover onto the router, and replace and tighten the cover screws.

9.Replace the power cord or cable.

10.Press and release the power button to power on the router. Verify that the POWER LED lights steadily.

11.Verify that the Crypto Module is correctly installed by issuing the show chassis hardware command, as shown in the following example:

user@host> show chassis hardware

 

 

Hardware inventory:

 

 

 

Item

Version

Part number

Serial number

Description

Chassis

 

 

JN1092BAEADB

J6350

Midplane

REV 03

710-014593

NR2489

 

System IO

REV 01

710-016210

NL3304

JX350 System IO

Crypto Module

 

 

 

Crypto

Acceleration

 

 

 

 

Routing Engine

REV 08

710-015273

NM4265

RE-J6350-3400

FPC 0

 

 

 

FPC

PIC 0

 

 

 

4x GE Base PIC

FPC 6

REV 00

750-015152

 

FPC

PIC 0

 

 

 

6x GE SFP uPIM

Xcvr 0

 

NON-JNPR

PC14DP3

SFP-SX

Xcvr 2

 

NON-JNPR

PC21M3E

SFP-SX

Power Supply 0

 

 

 

 

204Replacing Crypto Accelerator Modules on J4350 and J6350 Routers

Page 226
Image 226
Juniper Networks J6350 manual Installing a J4350 or j6350 Crypto Accelerator Module